- 206 -
CT-S2000
• Setting MSW 4 (a=4) (Black mark/Label model)
n b (Set Value) Function
48 (Default)
At the selection of Black mark/Label paper, enables auto
end-measurement.
1
49
At the selection of Black mark/Label paper, disables auto
end-measurement.
48 (Default) Finding top of form at power ON disabled.
2
49 Finding top of form at power ON enabled.
48 Feed & Cut at TOF disabled.
3
49 (Default) Feed & Cut at TOF enabled.
48 (Default) Uses thermal roll paper.
4
49 Uses Black mark paper/ label paper.
48 (Default) Detects paper position and black mark.
5
49 Detects paper position and inter-label distance.
48 (Default) Paper type selection disabled
6
49 Paper type selection enabled
7 48 (Default)
Reserved
48 Cut method is determined according to the cut command.
8
49 (Default)
Partial cut is performed regardless of cut command. (full
but by command: enabled).
* MSW 4-5 is valid only if black mark/label is set. If MSW4-4 is set for
thermal paper, it is invalid
* MSW4-8 is invalid when black mark/label is selected. Cut type for black
mark/label paper is only full cut.
• Setting MSW 5 (a=5)
n b (Set Value) Function
48 (Default) Buzzer sound enabled.
1
49 Buzzer sound disabled.
48 (Default) Basic calculation pitch (180 dpi / 360 dpi).
2
49 Basic calculation pitch (203 dpi / 406 dpi).
48 USB mode virtual serial.
3
49 (Default) USB mode printer class.
4 48 (Default) Reserved
5 48 (Default) Reserved
48 (Default) High quality printing mode disabled
6
49 High quality printing mode enabled
7 48 (Default) Reserved
8 48 (Default) Reserved
To Next Page
Loading...
