Citizen CT-S280 - Page 219

- 218 -
CT-P29x series
• Setting MSW 1 (a=1)
n b (Set Value) Function
48 (Default) Reports the power on.
1
49 Does not report power on.
48 (Default) Sets input buffer capacity to 4K bytes.
2
49 Sets input buffer capacity to 45 bytes. (Note)
48 (Default) Sets input buffer full and offline to be Busy.
3
49 Sets to be busy with input buffer full.
48 (Default)
At the occurrence of receiving error, replaces the data with
“?”.4
49 At the occurrence of receiving error, ignores the data.
48 (Default) Disables CR (0DH).
5
49 Enables CR (0DH).
6 48 (Default) Reserved
48 (Default) Does not reset at serial I/F pin 6.
7
49 Resets at serial I/F pin 6.
8 48 (Default) Reserved
• Setting MSW 2 (a=2)
n b (Set Value) Function
1 49 (Default) Reserved
48 Disables auto cutter.
2
49(Default) Enables auto cutter.
48 (Default) Enables stored printing.
3
49 Disables stored printing.
48 (Default) Immediately after digit reaches full, line-feed is taken.
4
49 Immediately after digit reaches full, data wait is taken.
48 (Default) After head-down* and PE recovery, prints as it is.
5
49
After head-down* and PE recovery, prints from the
beginning using PAGE MODE, barcode, image,
double-height printing, etc. as a unit.
48 Sets paper width to 80 mm.
6
49 Sets paper width to 58(60) mm.
7 48 (Default) Reserved
48 Enables PNE.
8
49 (Default) Disables PNE.
• Setting MSW 3 (a=3)
n b (Set Value) Function
48 (Default) After clearing cutter error, can be restored by Feed SW.
1
49 After clearing cutter error, cannot be restored by Feed SW.
2 48 (Default) Reserved
48 (Default) Resets with parallel pin 31.
3
49 Does not reset with parallel pin 31.
48 (Default) Uses thermal paper.
4
49 Uses Black mark paper.
48(Default) Used with 48 print columns
5
49 Used with 32 print columns.
6 48 (Default) Reserved
48 (Default) Sets EPSON compatible mode.
7
49 Sets CBM1000-compatible mode.
48 (Default)
Sets platen-open error during printing to be auto recovery
error.
8
49
Sets platen-open error during printing to be recoverable
error.