- 253 -
PMU2300III
• a=5: Sets printing density to the level specified by (nL+nH×256).
(nL+nH×256) Printing Density
65530 70%
65531 75%
65532 80%
65533 85%
65534 90%
65535 95%
0(Default) 100%
1 105%
2 110%
3 115%
4 120%
5 125%
6 130%
7 135%
8 140%
• a=6: Sets printing speed to the value specified by (nL+nH×256).
(nL+nH×256) Printing Speed
1 Printing speed level 1 (84%)
2 Printing speed level 2 (86%)
3 Printing speed level 3 (88%)
4 Printing speed level 4 (90%)
5 Printing speed level 5 (92%)
6 Printing speed level 6 (94%)
7 Printing speed level 7 (96%)
8 Printing speed level 8 (98%)
9 (Default) Printing speed level 9 (100%)
• a=130: Sets the auto retraction time length selected by (nL+nH×256).
If n = 0, time length is not set. (Retraction is done by GS R 0 command.)
1≤(nL+nH×256)≤32767
Unit: 100ms
Initial value: 50 (5000ms)
• a=131: Sets the time length of bezel LED ON at waiting selected by
(nL+nH×256).
1≤(nL+nH×256)≤32767
Unit: 100ms
Initial value: 0 (LED is kept on)
• a=132: Sets the time length of bezel LED ON at blinking selected by
(nL+nH×256).
2≤(nL+nH×256)≤3000
Unit: 100ms
Initial value: 5 (500ms)
• a=133: Sets the time length of bezel LED OFF at blinking selected by
(nL+nH×256).
2≤(nL+nH×256)≤3000
Unit: 100ms
Initial value: 5 (500ms)
To Next Page
Loading...
