- 254 -
PMU2300III
• a=134: Sets the state of bezel LED at waiting selected by (nL+nH×256).
(nL+nH×256)
Bezel LED state at waiting
0(Default) Off
1 On
2 Blinking
• a=135: Sets the state of bezel LED at printing selected by (nL+nH×256).
(nL+nH×256)
Bezel LED state at printing
0 Off
1(Default)
On
2 Blinking
• a=136: Sets the state of bezel LED at ejecting selected by (nL+nH×256).・
(nL+nH×256)
Bezel LED state at ejecting
0 Off
1 On
2(Default) Blinking
• a=202: Controls input buffer full Busy with the value selected by
(nL+nH×256) and controls Busy with output/cancel timing
(remaining capacity).
When Input Buffer
Capacity “Small” is Set
When Input Buffer
Capacity 4K Bytes
(Large) is Set
(nL+nH×256)
Output Cancel Output Cancel
1(Default) 16 26 128 256
2 16 40 128 512
3 30 50 72 256
4 30 60 72 512
• XON/XOFF is also output by the establishment of conditions.
• Ignores the data received when input buffer idle capacity is 0.
• a=213: Selects the flow control specified by (nL+nH×256) when virtual
COM is set.
(nL+nH×256) Flow control
1(Default) PC setting
2 DTR/DSR
3 XON/XOFF
To Next Page
Loading...
