dallmeier DLS 4 Installation And Configuration

DLS 4 / DLS 8 / 8 PLUS / DLS 16 / 16 PLUS
118Dallmeier electronic
16 HDD management
The Hard disk management shows all the hard disks and drives tted in the recorder
or connected externally. Individual HDDs can be enabled and disabled for the recording
process.
NOTE
All hard disk drives are enabled for recording in the default
conguration.
Ø Open the Hard disk management dialog using Setup > Recording > HDD management.
Fig. 16-1
The various drives are displayed separately by category (bus system) in a structure tree.
The total capacity available for recording is shown at the top right.
To enable or disable a hard disk drive for recording, check or uncheck the checkbox in the
Rec column.
RAID systems
RAID-Systems activate an additional dropdown box in the upper part of the dialog.
Fig. 16-2: Selection RAID
It is possible to deactivate RAID. The various HDD’s must be activated manually for recor-
ding, as described above.
Depending on the type and number of internal and external HDD’s (DAS-4 Eco or DAS-300),
RAID 1 or RAID 5 can also be activated. In this case the HDD’s are activated automatically
and no manual settings can be made.
Ø To change the conguration, select one of the options offered.
Ø Conrm with OK.

dallmeier DLS 4 Specifications

General

Brand	dallmeier
Model	DLS 4
Category	Measuring Instruments
Language	English