DLS 4 / DLS 8 / 8 PLUS / DLS 16 / 16 PLUS
50Dallmeier electronic
Fig. 8-11: Tracks Timer dialog
Ø Select all S-tracks (s) or the relevant LP-track in the Tracks section.
Ø Set Active and Inactive periods as described above.
Ø If necessary set Exceptions as described above.
Ø Finally conrm with OK.
NOTE
The Tracks Timer will be reset when the track mode is changed.
8.3.4 Areas
The Areas dialog enables the denition of active (relevant) image areas for motion detection.
Furthermore privacy zones for critical image areas can be dened.
8.3.4.1 Active areas
In default conguration the entire image is relevant for motion detection. Inactive areas can
be dened if motion in specic image areas should not be taken into account.
Ø Open the Areas dialog via Setup > Recording > Areas.
Fig. 8-12: Areas dialog / Active Areas