dallmeier DLS 4 Installation And Configuration

DLS 4 / DLS 8 / 8 PLUS / DLS 16 / 16 PLUS
19Dallmeier electronic
5.6 Mouse and keyboard
The mouse and keyboard can be connected either to a USB port or to the PS/2 port.
USB
Ø Connect the mouse and / or keyboard to any USB port (8).
PS/2
Ø Connect the mouse and / or keyboard to the Y-cable.
Ø Connect the Y-cable to the PS/2 port (9).
5.7 Contact IN
The Contact IN interface (16 and 17) allows various recorder functions to be started and
controlled by external devices.
The following specications apply for all contact inputs:
l Interfering pulses < 10 ms are ltered out
l Contact input must be < 1V for low level at 1 mA
l VdS calms a contact duration of min. 200 ms for alarm systems
Proceed as follows to connect the contact output on an external device:
Ø Use the supplied 18-pin Weidmüller plug connector.
Ø Connect the contact output on the external device to the plug connector.
Ø Align the plug connector correctly (routing).
Ø Check that the assignment is correct.
Ø Connect the plug connector to the 18-pin plug strip (16) on the recorder.
Regarding the contact inputs, a differentiation is made between contacts for individual ca-
meras and global contacts.
5.7.1 Global contacts
Fig. 5-2: Global contact inputs

dallmeier DLS 4 Specifications

General

Brand	dallmeier
Model	DLS 4
Category	Measuring Instruments
Language	English