dallmeier DLS 4 Installation And Configuration

DLS 4 / DLS 8 / 8 PLUS / DLS 16 / 16 PLUS
29Dallmeier electronic
Time is not set automatically despite good reception:
The deviation of the set time from the actual time is too large. In this case, set the time
manually rst. The set time may not deviate more than 1 000 seconds from the actual
time. Then activate the radio clock module.
7.3 System security
For functions with which external access is required, the corresponding ports on the system
must be open.
For system security reasons, the number of open ports should be kept to a minimum. This
is already carried out at the factory by blocking the ports denitely not required for Dallmeier
systems.
The few ports which are still relevant are enabled in the default setting to ensure full com-
patibility to the other Dallmeier units. If certain ports are not required for the current recorder
conguration, they can be deactivated in the System Security dialog.
For example, if the time setting of your system is not made by external systems (time ser-
vers), then the port for Timeserver can be deactivated.
Ø This dialog is accessed via Setup > System > System Security.
Fig. 7-6
Ø Activate the required protocols.
Ø Deactivate the not required protocols.
Ø Conrm with OK.
7.4 Options
The basic functions of the recorder can be set in the Options dialog.
Ø Open the Options dialog using Setup > System > Options.

dallmeier DLS 4 Specifications

General

Brand	dallmeier
Model	DLS 4
Category	Measuring Instruments
Language	English