DLS 4 / DLS 8 / 8 PLUS / DLS 16 / 16 PLUS
77Dallmeier electronic
Fig. 10-3
The name of the alarm host can be changed if necessary.
Ø Select an alarm host with a left click in the alarm host list.
Ø Open the virtual keyboard Change name.
Ø Enter a term without special characters as Name for alarm-host.
Ø Close the virtual keyboard with OK.
10.3.2 Connection
The specication of the connection type and the entry of the address data are made in the
Connection type section.
Take into account that the current recorder version supports message transmission via the
Ethernet interface only.
Ø Select an alarm host with a left click in the alarm host list.
Ø Select the transmission type Ethernet.
Ø Open the Ethernet/Tokenring dialog with Connection.
Fig. 10-4
Ø Enter the alarm host’s IP-Address.
Ø Set the maximum duration of a connection attempt as Ping Timeout (seconds).