DLS 4 / DLS 8 / 8 PLUS / DLS 16 / 16 PLUS
13Dallmeier electronic
4 Installation and mounting
The DLS is designed for stand-alone operation. As an option it may also be installed in a
19“ standard rack.
4.1 General Requirements
Unfavorable local conditions may shorten the life of the product or lead to malfunctions.
Do not operate DLS at places
l with large scale dust and dirt
l with steam or oil vapors (e.g. kitchen)
l with direct sunlight
l with unsuitable ambient temperatures
l near sources of strong radiation (e. g. X-rays, radio transmitters or magnetic elds)
l with corrosive surroundings (e.g. gases or salt water)
l with insufcient ventilation (e. g. closed cabinet)
Comply with all the safety instructions and technical data.
4.2 Stand-alone installation
The DLS may be freely positioned in a place respecting the requirements mentioned above.
Attention should be paid to the fact that all connections are freely accessible.
4.2.1 Requirements
Computer room
This device is not for use in a computer room as dened in the „Standard for Protection of
Electronic Computer/Data Processing Equipment, ANSI/NFPA 75“.
Secured room
Manipulation and sabotage danger. A stand-alone installation should be made in secured
rooms with restricted access only.
Socket-outlet
The used socket-outlet has to be installed near the device. It has to be easily accessible.
4.2.2 Installation
Ø Do not place the DLS upside down.
Ø Ensure a stable and horizontal surface.
Ø Ensure sufcient ventilation with 4 inch free space on the front, rear and right side.
To Next Page
Loading...
Need help?
General
