8-41 Parameters for signals
Option: Function:
[3403] PCD 3 Write to MCO
[3404] PCD 4 Write to MCO
[3405] PCD 5 Write to MCO
[3406] PCD 6 Write to MCO
[3407] PCD 7 Write to MCO
[3408] PCD 8 Write to MCO
[3409] PCD 9 Write to MCO
[3410] PCD 10 Write to MCO
[3421] PCD 1 Read from MCO
[3422] PCD 2 Read from MCO
[3423] PCD 3 Read from MCO
[3424] PCD 4 Read from MCO
[3425] PCD 5 Read from MCO
[3426] PCD 6 Read from MCO
[3427] PCD 7 Read from MCO
[3428] PCD 8 Read from MCO
[3429] PCD 9 Read from MCO
[3430] PCD 10 Read from MCO
[3440] Digital Inputs
[3441] Digital Outputs
[3450] Actual Position
[3451] Commanded Position
[3452] Actual Master Position
[3453] Slave Index Position
[3454] Master Index Position
[3455] Curve Position
[3456] Track Error
[3457] Synchronizing Error
[3458] Actual Velocity
[3459] Actual Master Velocity
[3460] Synchronizing Status
[3461] Axis Status
[3462] Program Status
[3464] MCO 302 Status
[3465] MCO 302 Control
[3470] MCO Alarm Word 1
[3471] MCO Alarm Word 2
[4280] Safe Option Status
[4285] Active Safe Func.
[4286] Safe Option Info
8-42 PCD write configuration
Range: Function:
Application
dependent*
[0 -
9999 ]
Select the parameters to be
assigned to the PCD's messages.
The number of available PCDs
depends on the message type. The
values in the PCDs will then be
8-42 PCD write configuration
Range: Function:
written to the selected parameters
as data values.
8-43 PCD read configuration
Range: Function:
Application
dependent*
[0 - 9999 ] Select the parameters to be
assigned to PCDs of the messages.
The number of available PCDs
depends on the message type.
PCDs contain the actual data
values of the selected parameters.
Parameter Descriptions FC 300 Programming Guide
3-90 MG33MD22 - VLT
®
is a registered Danfoss trademark
3
3
To Next Page
Loading...
Need help?
General