Danfoss VLT AutomationDrive

Contents
1 Introduction
1-1
1.1.1 Approvals 1-1
1.1.2 Symbols 1-1
1.1.3 Abbreviations 1-1
1.1.4 Definitions 1-2
1.1.5 Electrical Wiring - Control Cables 1-6
2 How to Program
2-1
2.1 The Graphical and Numerical Local Control Panels
2-1
2.1.1 How to Program on the Graphical LCP 2-1
2.1.2 The LCD Display 2-1
2.1.4 Display Mode 2-4
2.1.5 Display Mode - Selection of Readouts 2-4
2.1.6 Parameter Set-up 2-5
2.1.7 Quick Menu Key Functions 2-5
2.1.9 Main Menu Mode 2-8
2.1.10 Parameter Selection 2-8
2.1.14 Infinitely Variable Change of Numeric Data Value 2-9
2.1.16 Readout and Programming of Indexed Parameters 2-9
2.1.17 How to Program on the Numerical Local Control Panel 2-9
2.1.18 Local Control Keys 2-11
2.1.19 Initialization to Default Settings 2-11
3 Parameter Descriptions
3-1
3.2 Parameters: 0-** Operation and Display
3-2
3.3 Parameters: 1-** Load and Motor
3-13
3.3.10.1 PTC Thermistor Connection 3-25
3.3.10.2 KTY Sensor Connection 3-25
3.3.10.3 ETR 3-26
3.3.10.4 ATEX ETR 3-26
3.3.10.5 Klixon 3-27
3.4 Parameters: 2-** Brakes
3-29
3.5 Parameters: 3-** Reference / Ramps
3-34
3.6 Parameters: 4-** Limits/Warnings
3-44
3.7 Parameters: 5-** Digital In/Out
3-49
3.8 Parameters: 6-** Analog In/Out
3-69
3.9 Parameters: 7-** Controllers
3-78
3.10 Parameters: 8-** Communications and Options
3-84
Contents FC 300 Programming Guide
MG33MD22 - VLT
®
is a registered Danfoss trademark
Remote Site Products - 1-888-532-2706 - www.remotesiteproducts.com
http://www.remotesiteproducts.com/p-20872-Danfoss-131H4490-VLT-Automation-VT-Drive-VFD-FC302-460V-25-HP.aspx