Danfoss VLT AutomationDrive Programming Guide

3.19 Parameters: 18-** Data Readouts 2
18-36 Analog Input X48/2 [mA]
Range: Function:
0.000* [-20.000 - 20.000 ] View the actual current measured at
input X48/2.
18-37 Temp. Input X48/4
Range: Function:
0* [-500 - 500 ] View the actual temperature measured at
input X48/4. The temperature unit is based on
the selection in 35-00 Term. X48/4 Temp. Unit.
18-38 Temp. Input X48/7
Range: Function:
0* [-500 - 500 ] View the actual temperature measured at
input X48/7. The temperature unit is based on
the selection in 35-02 Term. X48/7 Temp. Unit.
18-39 Temp. Input X48/10
Range: Function:
0* [-500 - 500 ] View the actual temperature measured at
input X48/10. The temperature unit is based
on the selection in 35-04 Term. X48/10 Temp.
Unit.
18-60 Digital Input 2
Range: Function:
0* [0 - 65535 ] View the signal states from the active digital
inputs. '0' = no signal, '1' = connected signal.
18-90 Process PID Error
Range: Function:
0.0 %* [-200.0 - 200.0 %]
18-91 Process PID Output
Range: Function:
0.0 %* [-200.0 - 200.0 %]
18-92 Process PID Clamped Output
Range: Function:
0.0 %* [-200.0 - 200.0 %]
18-93 Process PID Gain Scaled Output
Range: Function:
0.0 %* [-200.0 - 200.0 %]
Parameter Descriptions FC 300 Programming Guide
3-150 MG33MD22 - VLT
®
is a registered Danfoss trademark
3
3
Remote Site Products - 1-888-532-2706 - www.remotesiteproducts.com
http://www.remotesiteproducts.com/p-20872-Danfoss-131H4490-VLT-Automation-VT-Drive-VFD-FC302-460V-25-HP.aspx

Danfoss VLT AutomationDrive Specifications

General

Supply Voltage	3 x 200-240 V ±10% 3 x 380-500 V ±10% 3 x 525-600 V ±10%
Enclosure	IP20
Output Power Range	0.25 kW - 1.5 MW
Communication Protocols	Modbus RTU
Protection Features	Overcurrent, Overvoltage, Undervoltage, Short circuit, Ground fault, Motor overload
Ambient Temperature Range	-10°C to +50°C (14°F to 122°F)