Danfoss VLT AutomationDrive Programming Guide

30-81 Brake Resistor (ohm)
Range: Function:
Application
dependent*
[Application
dependant]
Set the brake resistor value in
Ohms. This value is used for
monitoring the power to the
brake resistor in 2-13 Brake
Power Monitoring. This
parameter is only active in
drives with an integral dynamic
brake.
30-83 Speed PID Proportional Gain
Range: Function:
Application
dependent*
[0.0000 -
1.0000 ]
Enter the speed controller
proportional gain. Quick control
is obtained at high amplification.
However, if the amplification is
too great, the process may
become unstable.
Application
dependent*
[0.0000 -
1.0000 ]
Enter the speed controller
proportional gain. Quick control
is obtained at high amplification.
However, if the amplification is
too great, the process may
become unstable.
30-84 Process PID Proportional Gain
Range: Function:
0.100* [0.000 -
10.000 ]
Enter the process controller propor-
tional gain. Quick control is obtained at
high amplification. However, if the
amplification is too great, the process
may become unstable.
Parameter Descriptions FC 300 Programming Guide
MG33MD22 - VLT
®
is a registered Danfoss trademark 3-153
3
3
Remote Site Products - 1-888-532-2706 - www.remotesiteproducts.com
http://www.remotesiteproducts.com/p-20872-Danfoss-131H4490-VLT-Automation-VT-Drive-VFD-FC302-460V-25-HP.aspx

Danfoss VLT AutomationDrive Specifications

General

Supply Voltage	3 x 200-240 V ±10% 3 x 380-500 V ±10% 3 x 525-600 V ±10%
Enclosure	IP20
Output Power Range	0.25 kW - 1.5 MW
Communication Protocols	Modbus RTU
Protection Features	Overcurrent, Overvoltage, Undervoltage, Short circuit, Ground fault, Motor overload
Ambient Temperature Range	-10°C to +50°C (14°F to 122°F)