Danfoss VLT AutomationDrive Programming Guide

9-83 Defined Parameters (4)
Array [116]
No LCP access
Read only
Range: Function:
0 * [0 - 9999 ] This parameter displays a list of all the defined
Adjustable frequency drive parameters available
for Profibus.
9-84 Defined Parameters (5)
Range: Function:
0* [0 - 9999 ] This parameter displays a list of all the defined
Adjustable frequency drive parameters available
for Profibus.
9-90 Changed Parameters (1)
Array [116]
No LCP access
Read only
Range: Function:
0 * [0 - 9999 ] This parameter displays a list of all the
Adjustable frequency drive parameters
deviating from default setting.
9-91 Changed Parameters (2)
Array [116]
No LCP access
Read only
Range: Function:
0 * [0 - 9999 ] This parameter displays a list of all the
Adjustable frequency drive parameters
deviating from default setting.
9-92 Changed Parameters (3)
Array [116]
No LCP access
Read only
Range: Function:
0 * [0 - 9999 ] This parameter displays a list of all the
Adjustable frequency drive parameters
deviating from default setting.
9-94 Changed Parameters (5)
Array [116]
No LCP Address
Read only
Range: Function:
0 * [0 - 9999 ] This parameter displays a list of all the
Adjustable frequency drive parameters
deviating from default setting.
Parameter Descriptions FC 300 Programming Guide
3-100 MG33MD22 - VLT
®
is a registered Danfoss trademark
3
3
Remote Site Products - 1-888-532-2706 - www.remotesiteproducts.com
http://www.remotesiteproducts.com/p-20872-Danfoss-131H4490-VLT-Automation-VT-Drive-VFD-FC302-460V-25-HP.aspx

Danfoss VLT AutomationDrive Specifications

General

Supply Voltage	3 x 200-240 V ±10% 3 x 380-500 V ±10% 3 x 525-600 V ±10%
Enclosure	IP20
Output Power Range	0.25 kW - 1.5 MW
Communication Protocols	Modbus RTU
Protection Features	Overcurrent, Overvoltage, Undervoltage, Short circuit, Ground fault, Motor overload
Ambient Temperature Range	-10°C to +50°C (14°F to 122°F)