Danfoss VLT AutomationDrive Programming Guide

3.11 Parameters: 9-** Profibus
3-94
3.12 Parameters: 10-** DeviceNet CAN Fieldbus
3-101
3.13 Parameters: 12-** Ethernet
3-105
3.14 Parameters: 13-** Smart Logic Control
3-110
3.15 Parameters: 14-** Special Functions
3-127
3.16 Parameters: 15-** Drive Information
3-136
3.17 Parameters: 16-** Data Read-outs
3-141
3.18 Parameters: 17-** Motor Feedb. Option
3-148
3.19 Parameters: 18-** Data Readouts 2
3-150
3.20 Parameters: 30-** Special Features
3-151
3.21 Parameters: 35-** Sensor Input Option
3-154
4 Parameter Lists
4-1
4.1.1 Conversion 4-1
4.1.2 Active/Inactive Parameters in Different Drive Control Modes 4-2
5 Troubleshooting
5-1
5.1.1 Warnings/Alarm Messages 5-1
6 Index
6-1
Contents FC 300 Programming Guide
MG33MD22 - VLT
®
is a registered Danfoss trademark
Remote Site Products - 1-888-532-2706 - www.remotesiteproducts.com
http://www.remotesiteproducts.com/p-20872-Danfoss-131H4490-VLT-Automation-VT-Drive-VFD-FC302-460V-25-HP.aspx

Danfoss VLT AutomationDrive Specifications

General

Supply Voltage	3 x 200-240 V ±10% 3 x 380-500 V ±10% 3 x 525-600 V ±10%
Enclosure	IP20
Output Power Range	0.25 kW - 1.5 MW
Communication Protocols	Modbus RTU
Protection Features	Overcurrent, Overvoltage, Undervoltage, Short circuit, Ground fault, Motor overload
Ambient Temperature Range	-10°C to +50°C (14°F to 122°F)