Danfoss VLT AutomationDrive Programming Guide

15-62 Option Ordering No
Range: Function:
0 * [0 - 0 ] Shows the ordering number for the installed
options.
15-63 Option Serial No
Range: Function:
0 * [0 - 0 ] View the installed option serial number.
15-92 Defined Parameters
Array [1000]
Range: Function:
0 * [0 - 9999 ] View a list of all defined parameters in the
Adjustable frequency drive. The list ends with 0.
15-93 Modified Parameters
Array [1000]
Range: Function:
0 * [0 - 9999 ] View a list of the parameters that have been
changed from their default setting. The list
ends with 0. Changes may not be visible until
up to 30 sec. after implementation.
15-99 Parameter Metadata
Array [30]
Range: Function:
0* [0 - 9999 ] This parameter contains data used by the MCT
10 Set-up Software.
Parameter Descriptions FC 300 Programming Guide
3-140 MG33MD22 - VLT
®
is a registered Danfoss trademark
3
3
Remote Site Products - 1-888-532-2706 - www.remotesiteproducts.com
http://www.remotesiteproducts.com/p-20872-Danfoss-131H4490-VLT-Automation-VT-Drive-VFD-FC302-460V-25-HP.aspx

Danfoss VLT AutomationDrive Specifications

General

Supply Voltage	3 x 200-240 V ±10% 3 x 380-500 V ±10% 3 x 525-600 V ±10%
Enclosure	IP20
Output Power Range	0.25 kW - 1.5 MW
Communication Protocols	Modbus RTU
Protection Features	Overcurrent, Overvoltage, Undervoltage, Short circuit, Ground fault, Motor overload
Ambient Temperature Range	-10°C to +50°C (14°F to 122°F)