E-GENIUS
108
AV500/AV900 2D CAMERA
Padding
Enter a value to use for padding between the outline and the image.
ONLINE AND CONTINUOUS MODE
If Online or Continuous Mode have been selected as the Operating Mode, the following
parameters will be available.
Minimum Settings
Enter the minimum detection size setting for the object length.
Maximum Settings
Enter the maximum detection size setting for the object length.
SIDE BY SIDE VERIFICATION SETTINGS
If Side by Side Verification have been enabled in Operating Mode, several parameters
are revealed.
The Dimensioner has the ability to indicate when packages are too close to one another on the
belt. This is called a
Side By Side Condition. However some parcels like cases of water can
cause a false identification by the Dimensioner. The Side by Side Verification Settings options
allow the AV500/900 to use the bar code data to ignore the SBS message from the
dimensioner.
Auto Learn Settings
Auto Learn
Click on the drop-down to select Disable or Enable. When Auto Learn is enabled Count
Before Ignoring SBS, and Table Entry Timeout parameters are revealed.
Auto Learn sets the camera to keep track of the bar codes read and identifies those with an SBS
message associated. If the barcode does have the SBS message, the camera starts a counter. If
it receives consecutive SBS messages for that bar code within the "
Count Before Ignoring
SBS
" value, the camera ignores the SBS condition sent by the dimensioner for the amount of
time entered in the "
Table Entry Timeout value".
Count before Ignoring SBS
Enter the Count Before Ignoring SBS value.