Dell Force10 C150 - Create a Virtual Stack Unit on an S-Series Stack; Display Information about an S-Series Stack

1036 | Stacking S-Series Switches
www.dell.com | support.dell.com
Create a Virtual Stack Unit on an S-Series Stack
Use virtual stack units to configure ports on the stack before adding a new unit, or to prevent FTOS from
assigning a particular stack-number.
Display Information about an S-Series Stack
Task Command Syntax Command Mode
Create a virtual stack unit.
stack-unit provision
CONFIGURATION
Task Command Syntax Command Mode
Display for stack-identity, status, and
hardware information on every unit in a
stack (Figure 50-18).
show system
EXEC Privilege
Display most of the information in show
system
, but in a more convenient tabular
form (Figure 50-19).
show system brief
EXEC Privilege
Display the same information in show
system
, but only for the specified unit
(Figure 50-19).
show system stack-unit
EXEC Privilege
Display topology and stack link status for
the entire stack. The available options
separate the show system stack-port
output into topology information from link
status information (Figure 50-19).
show system stack-ports [status | topology] EXEC Privilege