Dell Force10 C150 - Configuring BFD for Static Routes

180 | Bidirectional Forwarding Detection
www.dell.com | support.dell.com
To re-enable BFD on an interface:
Configuring BFD for Static Routes
BFD gives systems a link state detection mechanism for static routes. With BFD, systems are notified to
remove static routes from the routing table as soon as the link state change occurs, rather than having to
wait until packets fail to reach their next hop.
Configuring BFD for static routes is a three-step process:
1. Enable BFD globally. See Enabling BFD globally on page 176.
2. On the local system, establish a session with the next hop of a static route. See page 180.
3. On the remote system, establish a session with the physical port that is the origin of the static route.
See Establishing a session on physical ports on page 176.
Related configuration tasks
• Change session parameters. See page 181.
• Disable BFD for all static routes. See page 181.
Establishing sessions for static routes
Sessions are established for all neighbors that are the next hop of a static route.
Figure 9-9. Enabling BFD for Static Routes
Step Task Command Syntax Command Mode
1 Enable BFD on an interface.
bfd enable
INTERFACE
2.2.2.1/24
fnC0039mp
4/24
2/1
2/2
6/0
Force10(config)# interface gigabitethernet 2/2
Force10(conf-if-gi-2/2)# ip address 2.2.3.1/24
Force10(conf-if-gi-2/2)# no shutdown
Force10(config)# interface gigabitethernet 4/24
Force10(conf-if-gi-4/24)# ip address 2.2.2.1/24
Force10(conf-if-gi-4/24)# no shutdown
Force10(config)# ip route 2.2.3.0/24 2.2.2.2
Force10(config)# ip route bfd
Force10(config)# interface gigabitethernet 6/0
Force10(conf-if-gi-6/0)# ip address 2.2.3.2/24
Force10(conf-if-gi-6/0)# no shutdown
Force10(config)# interface gigabitethernet 2/1
Force10(conf-if-gi-2/1)# ip address 2.2.2.2/24
Force10(conf-if-gi-2/1)# no shutdown
Force10(conf-if-gi-2/1)# bfd neighbor 2.2.2.1
R1
2.2.3.2/24
2.2.3.1/242.2.2.2/24
R2
R3