Dell Force10 C150 - Conventions; Information Symbols; Related Documents

34 | About this Guide
www.dell.com | support.dell.com
Conventions
This document uses the following conventions to describe command syntax:
Information Symbols
Table 1-1 describes symbols contained in this guide.
Related Documents
For more information about the Dell Force10 E-Series, C-Series, and S-Series refer to the following
documents:
• FTOS Command Reference
• Installing and Maintaining the <Dell Force10 chassis> System
• FTOS Release Notes
Convention Description
keyword
Keywords are in bold and should be entered in the CLI as listed.
parameter
Parameters are in italics and require a number or word to be entered in the CLI.
{X} Keywords and parameters within braces must be entered in the CLI.
[X] Keywords and parameters within brackets are optional.
x | y Keywords and parameters separated by bar require you to choose one.
Table 1-1. Information Symbols
Symbol Warning Description
FTOS Behavior This symbol informs you of an FTOS behavior. These behaviors are
inherent to the Dell Force10 system or FTOS feature and are
non-configurable.
ces
Platform Specific
Feature
This symbol informs you of a feature that supported on one or two
platforms only: e is for E-Series, c is for C-Series, s is for S-Series.
e
t
e
x
E-Series Specific
Feature/Command
If a feature or command applies to only one of the E-Series platforms, a
separate symbol calls this to attention: e
t
for the TeraScale or e
x
for
the ExaScale.
*
Exception This symbol is a note associated with some other text on the page that is
marked with an asterisk.