1182 | C-Series Debugging and Diagnostics
www.dell.com | support.dell.com
Monitoring hardware components with SNMP
The SNMP traps and OIDs in Table 60-4 provide information on C-Series hardware components.
Table 60-4. SNMP Traps and OIDs
OID String OID Name Description
RPM
.1.3.6.1.4.1.6027.3.1.1.3.8 chRPMMajorAlarmStatus Fault status of the major alarm LED on the RPM
.1.3.6.1.4.1.6027.3.1.1.3.9 chRPMMinorAlarmStatus Fault status of the minor alarm LED on the RPM
.1.3.6.1.4.1.6027.3.1.1.4.0.11 chAlarmRpmUp Trap generated when the status of primary or
secondary RPM changes to up and running
.1.3.6.1.4.1.6027.3.1.1.4.0.12 chAlarmRpmDown Trap generated when the status of primary or
secondary RPM changes to down, either by
software reset or by being physically removed from
the chassis
Line Card
.1.3.6.1.4.1.6027.3.1.1.2.3.1.15 chSysCardOperStatus Operational status of the card.
• If the chSysCardAdminStatus is up, the valid
state is ready—the card is present and ready and
the chSysCardOperStatus status is up.
• If the chSysCardAdminStatus is down the
service states can be:
• offline: the card is not used.
• cardNotmatch: the card does not
match what is configured
• cardProblem: a hardware
problem has been detected on the
card.
• diagMode: the card is in the
diagnostic mode.
Note: chSysCardFaultStatus is supported only the
C-Series.
.1.3.6.1.4.1.6027.3.1.1.4.0.1 chAlarmCardDown Trap reported when a card operational status
changes to down
.1.3.6.1.4.1.6027.3.1.1.4.0.2 chAlarmCardUp Trap reported when a card operational status
changes to up
.1.3.6.1.4.1.6027.3.1.1.4.0.3 chAlarmCardReset Trap reported when a card is reset
.1.3.6.1.4.1.6027.3.1.1.4.0.7 chAlarmCardProblem Trap reported when a card operational status
changes to card problem
.1.3.6.1.4.1.6027.3.1.1.1.4.0.5 chAlarmCardMismatch Trap generated when the configured card does not
match the installed card
.1.3.6.1.4.1.6027.3.1.1.1.4.0.6 chAlarmCardRemove Trap generated when a card is removed
Power Supply Unit
To Next Page
Loading...
