EasyManuals Logo

Dell Force10 C150 Configuration Guide

Dell Force10 C150
1262 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #1025 background imageLoading...
Page #1025 background image
Stacking S-Series Switches | 1025
Figure 50-6. Adding a Standalone with a Lower MAC Address but Higher Priority to a Stack—After
Management Access on S-Series Stacks
You can access the stack via the console port or VTY line.
• Console access: You may access the stack through the console port of the stack manager only. Like a
standby RPM, the console port of the standby unit does not provide management capability; only a
limited number of commands are available. Member units provide a severely limited set of commands,
as shown in Figure 50-7.
• Remote access: You may access the stack with SNMP, SSH, or Telnet through any enabled, Layer 3
interface on any stack unit. There is no dedicated management port or management route table.
-------------------------------STANDALONE AFTER CONNECTION----------------------------------
Standalone#00:18:27: %STKUNIT2-M:CP %CHMGR-5-STACKUNITDETECTED: Stack unit 0 present
00:18:27: %STKUNIT2-M:CP %CHMGR-5-STACKUNITDETECTED: Stack unit 1 present
00:18:40: %STKUNIT2-M:CP %CHMGR-2-STACKUNIT_DOWN: Stack unit 0 down - card removed
00:18:40: %STKUNIT2-M:CP %CHMGR-2-STACKUNIT_DOWN: Stack unit 1 down - card removed
00:19:30: %STKUNIT2-M:CP %POLLMGR-2-ALT_STACK_UNIT_STATE: Alternate Stack-unit i
s present
00:19:30: %STKUNIT2-M:CP %CHMGR-5-STACKUNITDETECTED: Stack unit 0 present
00:19:30: %STKUNIT2-M:CP %CHMGR-5-STACKUNITDETECTED: Stack unit 1 present
[remaining bootup messages omitted]
------------------------------------STACK AFTER CONNECTION----------------------------------
Stack#3w1d15h: %STKUNIT1-M:CP %POLLMGR-2-ALT_STACK_UNIT_STATE: Alternate Stack-unit is not
present
3w1d15h: %STKUNIT1-M:CP %CHMGR-5-STACKUNITDETECTED: Stack unit 2 present
Going for reboot. Reason is Stack merge
3w1d15h: %STKUNIT1-M:CP %CHMGR-2-STACK_UNIT_DOWN: Stack-unit 0 down - card removed
[bootup messages omitted]
Stack#show system brief
Stack MAC : 00:01:e8:d5:ef:81
-- Stack Info --
Unit UnitType Status ReqTyp CurTyp Version Ports
---------------------------------------------------------------------------
0 Member online S50V S50V 7.8.1.0 52
1 Standby online S50N S50N 7.8.1.0 52
2 Management online S50V S50V 7.8.1.0 52
3 Member not present
4 Member not present
5 Member not present
6 Member not present
7 Member not present

Table of Contents

Other manuals for Dell Force10 C150

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Dell Force10 C150 and is the answer not in the manual?

Dell Force10 C150 Specifications

General IconGeneral
BrandDell
ModelForce10 C150
CategoryServer
LanguageEnglish

Related product manuals