Force10 Service Agent | 351
You must still explicitly enable messaging for each recipient, including the default recipient.
Each recipient has a (user-configurable) mnemonic label. FTOS creates a CLI context based on this label
from which you can enable messaging and modify the E-mail parameters for the recipient. You can enter
the context for a recipient by entering the command
server label from the CALLHOME context. For
example, the default label is Force10. Enter the context conf-callhome-Force10 by entering the command
server Force10, as shown in Figure 16-2.
You may enable messaging for all recipients at once, or enable messaging for each recipient individually.
Add Additional Recipients of FTSA E-mails
You can add four more recipients for FTSA E-mails, in addition to Dell Force10 TAC and the
administrator, for a total of five recipients.
Task Command Command Mode
Enable messaging for all recipients.
enable-all
CALLHOME
Enable messaging for a individual recipient.
enable
CALLHOME <SERVER-LABEL>
To Next Page
Loading...
