Dell Force10 C150 - Mark Egress Packets with a DEI Value

964 | Service Provider Bridging
www.dell.com | support.dell.com
Mark Egress Packets with a DEI Value
On egress, you can set the DEI value according to a different mapping than ingress (see Honor the
Incoming DEI Value).
FTOS#show interface dei-honor
Default Drop precedence: Green
Interface CFI/DEI Drop precedence
-------------------------------------------------------------
Gi 0/1 0 Green
Gi 0/1 1 Yellow
Gi 8/9 1 Red
Gi 8/40 0 Yellow
Task Command Syntax Command Mode
Set the DEI value on egress according to the color
currently assigned to the packet.
dei mark {green | yellow} {0 | 1} INTERFACE
Display the DEI-marking configuration. show interface dei-mark [interface slot/
port | linecard number port-set number]
EXEC Privilege
FTOS#show interface dei-mark
Default CFI/DEI Marking: 0
Interface Drop precedence CFI/DEI
------------------------------------------------
Gi 0/1 Green 0
Gi 0/1 Yellow 1
Gi 8/9 Yellow 0
Gi 8/40 Yellow 0
Task Command Syntax Command Mode