Dell Force10 C150 Configuration Guide

802.3ah | 97
Configure Link Layer OAM
Configuring Link Layer OAM is a two-step process:
1. Enable Link Layer OAM. See page 97.
2. Enable any or all of the following:
a Link Performance Event Monitoring on page 99
b Remote Failure Indication on page 102
c Remote Loopback on page 103
Related Configuration Tasks
• Adjust the OAMPDU Transmission Parameters on page 99
• Display Link Layer OAM Configuration and Statistics on page 104
• Manage Link Layer OAM on page 106
Enable Link Layer OAM
Link Layer OAM is disabled by default. Enabling it places the system in Active mode and initiates OAM
discovery.Both peers on the link must be have link performance event monitoring enabled for discovery to
complete.
Task Command Syntax Command Mode
Enable Ethernet OAM.
ethernet oam
Default: Disabled
INTERFACE
Display the OAM discovery status. show ethernet oam discovery interface interface EXEC Privilege

Dell Force10 C150 Specifications

General

Brand	Dell
Model	Force10 C150
Category	Server
Language	English