Dell Force10 C150 - Display Ethernet CFM Statistics

802.1ag | 91
Three values are given within the trap messages: MD Index, MA Index, and MPID. You can reference
these values against the output of
show ethernet cfm domain and show ethernet cfm maintenance-points
local mep
.
FTOS#show ethernet cfm maintenance-points local mep
-------------------------------------------------------------------------------
MPID Domain Name Level Type Port CCM-Status
MA Name VLAN Dir MAC
-------------------------------------------------------------------------------
100 cfm0 7 MEP Gi 4/10 Enabled
test0 10 DOWN 00:01:e8:59:23:45
FTOS(conf-if-gi-0/6)#do show ethernet cfm domain
Domain Name: My_Name
MD Index: 1
Level: 0
Total Service: 1
Services
MA-Index MA-Name VLAN CC-Int X-CHK Status
1 test 0 1s enabled
Domain Name: Your_Name
MD Index: 2
Level: 2
Total Service: 1
Services
MA-Index MA-Name VLAN CC-Int X-CHK Status
1 test 100 1s enabled
Display Ethernet CFM Statistics
Task Command Syntax Command Mode
Display MEP CCM statistics. show ethernet cfm statistics [domain {name | level}
vlan-id
vlan-id mpid mpid
EXEC Privilege
FTOS# show ethernet cfm statistics
Domain Name: Customer
Domain Level: 7
MA Name: My_MA
MPID: 300
CCMs:
Transmitted: 1503 RcvdSeqErrors: 0
LTRs:
Unexpected Rcvd: 0
LBRs:
Received: 0 Rcvd Out Of Order: 0
Received Bad MSDU: 0
Transmitted: 0