Dell Force10 C150 - Navigating CLI Modes

Configuration Fundamentals | 37
Figure 2-2. CLI Modes in FTOS
Navigating CLI Modes
The FTOS prompt changes to indicate the CLI mode. Table 2-1 lists the CLI mode, its prompt, and
information on how to access and exit this CLI mode. You must move linearly through the command
modes, with the exception of the
end command which takes you directly to EXEC Privilege mode; the exit
command moves you up one command mode level.
Note: Sub-CONFIGURATION modes all have the letters “conf” in the prompt with additional modifiers to
identify the mode and slot/port information. These are shown in Table 2-1.
EXEC
EXEC Privilege
CONFIGURATION
ARCHIVE
AS-PATH ACL
INTERFACE
GIGABIT ETHERNET
10 GIGABIT ETHERNET
INTERFACE RANGE
LOOPBACK
MANAGEMENT ETHERNET
NULL
PORT-CHANNEL
SONET
VLAN
VRRP
IP
IPv6
IP COMMUNITY-LIST
IP ACCESS-LIST
STANDARD ACCESS-LIST
EXTENDED ACCESS-LIST
LINE
AUXILIARY
CONSOLE
VIRTUAL TERMINAL
MAC ACCESS-LIST
MONITOR SESSION
MULTIPLE SPANNING TREE
Per-VLAN SPANNING TREE
PREFIX-LIST
RAPID SPANNING TREE
REDIRECT
ROUTE-MAP
ROUTER BGP
ROUTER ISIS
ROUTER OSPF
ROUTER RIP
SPANNING TREE
TRACE-LIST