Dell Force10 C150 - View CAM Usage

292 | Content Addressable Memory
www.dell.com | support.dell.com
Figure 11-6. View CAM-ACl settings on C-Series and S-Series
View CAM Usage
View the amount of CAM space available, used, and remaining in each partition (including IPv4Flow and
Layer 2 ACL sub-partitions) using the command
show cam-usage from EXEC Privilege mode, as shown in
Figure 11-7.
FTOS# show cam-acl
-- Chassis Cam ACL --
Current Settings(in block sizes)
L2Acl : 2
Ipv4Acl : 2
Ipv6Acl : 2
Ipv4Qos : 2
L2Qos : 2
L2PT : 1
IpMacAcl : 2
VmanQos : 0
VmanDualQos : 0
-- Line card 0 --
Current Settings(in block sizes)
L2Acl : 2
Ipv4Acl : 2
Ipv6Acl : 2
Ipv4Qos : 2
L2Qos : 2
L2PT : 1
IpMacAcl : 2
VmanQos : 0
VmanDualQos : 0
-- Line card 6 --
Current Settings(in block sizes)
L2Acl : 2
Ipv4Acl : 2
Ipv6Acl : 2
Ipv4Qos : 2
L2Qos : 2
L2PT : 1
IpMacAcl : 2
VmanQos : 0
VmanDualQos : 0