460 | Interfaces
www.dell.com | support.dell.com
Dynamic Counters
By default, counting for the following four applications is enabled:
• IPFLOW
• IPACL
• L2ACL
• L2FIB
For remaining applications, FTOS automatically turns on counting when the application is enabled, and is
turned off when the application is disabled. Please note that if more than four counter-dependent
applications are enabled on a port pipe, there is an impact on line rate performance.
The following counter-dependent applications are supported by FTOS:
• Egress VLAN
• Ingress VLAN
• Next Hop 2
• Next Hop 1
• Egress ACLs
• ILM
• IP FLOW
• IP ACL
• IP FIB
• L2 ACL
• L2 FIB
To Next Page
Loading...
