Dell Force10 C150 Configuration Guide

66 | System Management
www.dell.com | support.dell.com
Configure a UNIX Logging Facility Level
Facility is a message tag used to describe the application or process that submitted the log message. You
can save system log messages with a UNIX system logging facility:
Display non-default settings using the
show running-config logging command from EXEC mode, as
shown in Figure 4-3.
Figure 4-3. show running-config logging Command Example
Command Syntax Command Mode Purpose
logging facility [facility-type] CONFIGURATION Specify one of the following parameters.
• auth (for authorization messages)
• cron (for system scheduler messages)
• daemon (for system daemons)
• kern (for kernel messages)
• local0 (for local use)
• local1 (for local use)
• local2 (for local use)
• local3 (for local use)
• local4 (for local use)
• local5 (for local use)
• local6 (for local use)
• local7 (for local use). This is the default.
• lpr (for line printer system messages)
• mail (for mail system messages)
• news (for USENET news messages)
• sys9 (system use)
• sys10 (system use)
• sys11 (system use)
• sys12 (system use)
• sys13 (system use)
• sys14 (system use)
• syslog (for syslog messages)
• user (for user programs)
• uucp (UNIX to UNIX copy protocol)
The default is local7.
FTOS#show running-config logging
!
logging buffered 524288 debugging
service timestamps log datetime msec
service timestamps debug datetime msec
!
logging trap debugging
logging facility user
logging source-interface Loopback 0
logging 10.10.10.4
FTOS#

Dell Force10 C150 Specifications

General

Brand	Dell
Model	Force10 C150
Category	Server
Language	English