688 | Object Tracking
www.dell.com | support.dell.com
Displaying Tracked Objects
You can display the currently configured objects used to track Layer 2 and Layer 3 interfaces, and IPv4
and IPv6 routes, by entering the following
show commands:
•
show track [object-id [brief] | interface [brief] [vrf vrf-name] | ip route [brief] [vrf vrf-name] | resolution |
vrf vrf-name [brief] | brief]
Use the show track command to display the configuration and status of currently tracked Layer 2 or
Layer 3 interfaces, IPv4 or IPv6 routes, or a VRF instance. You can also display the currently config-
ured per-protocol resolution values used to scale route metrics when tracking metric thresholds.
Figure 31-9. Command Example: show track
Figure 31-10. Command Example: show track brief
FTOS#show track
Track 1
IP route 23.0.0.0/8 reachability
Reachability is Down (route not in route table)
2 changes, last change 00:16:08
Tracked by:
Track 2
IPv6 route 2040::/64 metric threshold
Metric threshold is Up (STATIC/0/0)
5 changes, last change 00:02:16
Metric threshold down 255 up 254
First-hop interface is GigabitEthernet 13/2
Tracked by:
VRRP GigabitEthernet 7/30 IPv6 VRID 1
Track 3
IPv6 route 2050::/64 reachability
Reachability is Up (STATIC)
5 changes, last change 00:02:16
First-hop interface is GigabitEthernet 13/2
Tracked by:
VRRP GigabitEthernet 7/30 IPv6 VRID 1
Track 4
Interface GigabitEthernet 13/4 ip routing
IP routing is Up
3 changes, last change 00:03:30
Tracked by:
Track 5
IP route 192.168.0.0/24 reachability, Vrf: red
Reachability is Up (CONNECTED)
3 changes, last change 00:02:55
First-hop interface is GigabitEthernet 13/4
Tracked by:
Router# show track brief
ResId Resource Parameter State LastChange
1 IP route reachability 10.16.0.0/16 Up 00:01:08
2 Interface line-protocol Ethernet0/2 Down 00:05:00
3 Interface ip routing VLAN100 Up 01:10:05
To Next Page
Loading...
