Dell Force10 C150 - Change Your CAM-Profile on an E-Series System; Configuration Task List for Ipv6

496 | IPv6 Addressing
www.dell.com | support.dell.com
Configuration Task List for IPv6
This section contains information regarding the following:
• Change your CAM-Profile on an E-Series system (mandatory)
• Adjust your CAM-Profile on an C-Series or S-Series
• Assign an IPv6 Address to an Interface
• Assign a Static IPv6 Route
• Telnet with IPv6
• SNMP over IPv6
• Show IPv6 Information
• Clear IPv6 Routes
Change your CAM-Profile on an E-Series system
The cam-profile command is supported only on platform e
Change your CAM profile to the CAM ipv6-extacl before doing any further IPv6 configuration. Once the
CAM profile is changed, save the configuration and reboot your router.
Figure 22-4 displays the IPv6 CAM profile summary for a chassis that already has IPv6 CAM profile
configured. Figure 22-5 shows the full IPv6 CAM profiles. Refer to Chapter 11, Content Addressable
Memory, on page 281 for complete information regarding CAM configuration.
Figure 22-4. Command Example: show cam-profile summary (E-Series)
Command Syntax Command Mode Purpose
cam-profile ipv6-extacl
microcode ipv6-extacl
chassis
| linecard slot
EXEC Privileged Enable the CAM profile with IPv6 extended ACLs
on the entire chassis or on a specific linecard
chassis changes the CAM profile for all linecards
in the chassis
linecard slot/port changes the CAM profile only
for the specified slot
FTOS#show cam-profile summary
-- Chassis CAM Profile --
: Current Settings : Next Boot
Profile Name : IPV6-ExtACL : IPV6-ExtACL
MicroCode Name : IPv6-ExtACL : IPv6-ExtACL
-- Line card 1 --
: Current Settings : Next Boot
Profile Name : IPV6-ExtACL : IPV6-ExtACL
MicroCode Name : IPv6-ExtACL : IPv6-ExtACL
FTOS#