Dell Force10 C150 - Displaying Remote-Port Mirroring Configurations

828 | Port Monitoring
www.dell.com | support.dell.com
Displaying Remote-Port Mirroring Configurations
To display the current configuration of remote port mirroring for a specified session, enter the show config
command in MONITOR SESSION configuration mode.
To display the currently configured source and destination sessions for remote port mirroring on a switch,
enter the
show monitor session command in EXEC Privilege mode.
To display the current configuration of the reserved VLAN, enter the
show vlan command.
FTOS(conf-mon-sess-50)# show config
!
monitor session 50
source GigabitEthernet 1/2 destination remote-vlan 50 direction both mode Remote-Port-Mirroring
source vlan 4, vlan 11 - 12, destination remote-vlan 50 direction both mode Remote-Port-Mirroring
no disable
FTOS# show monitor session
SessionID Source Destination Direction Mode Type
--------- ------ ----------- --------- ---- ----
50 Gi 1/2 remote-vlan 50 both Remote-Port-Mirroring Port-based
50 Po 1 remote-vlan 50 both Remote-Port-Mirroring Port-based
20 Gi 1/3 remote-vlan 60 both Remote-Port-Mirroring Flow-based
10 remote-vlan 101 Gi 1/4 N/A Remote-Port-Mirroring N/A
Session 50: Source session monitors a source port and source
port-channel using VLAN 50
Session 20: Source session monitors a source port configured
for flow-based monitoring using VLAN 50 at a destination
port-channel
Session 10: Destination session receives mirrored traffic on
VLAN 101 at a destination port
FTOS(conf-if-gi-1/2)# show vlan
Codes: * - Default VLAN, G - GVRP VLANs, R - Remote Port Mirroring VLANs,
P - Primary, C - Community, I - Isolated
Q: U - Untagged, T - Tagged
x - Dot1x untagged, X - Dot1x tagged
G - GVRP tagged, M - Vlan-stack
NUM Status Q Ports
* 1 Inactive
R,G 2 Active T Gi 13/7