Dell Force10 C150 - Assign an Ip Address to a Port Channel; Delete or Disable a Port Channel

Interfaces | 435
To add a port channel to a VLAN, use either of the following commands:
To remove a port channel from a VLAN, use either of the following commands:
To see which port channels are members of VLANs, enter the
show vlan command in the EXEC Privilege
mode.
Assign an IP address to a port channel
You can assign an IP address to a port channel and use port channels in Layer 3 routing protocols.
To assign an IP address, use the following command in the INTERFACE mode:
Delete or disable a port channel
To delete a port channel, you must be in the CONFIGURATION mode and use the no interface
portchannel
channel-number command.
When you disable a port channel (using the
shutdown command) all interfaces within the port channel are
operationally down also.
Command Syntax Command Mode Purpose
tagged port-channel id number
INTERFACE
VLAN
Add the port channel to the VLAN as a tagged
interface. An interface with tagging enabled can
belong to multiple VLANs.
untagged port-channel id number INTERFACE
VLAN
Add the port channel to the VLAN as an untagged
interface. An interface without tagging enabled can
belong to only one VLAN.
Command Syntax Command Mode Purpose
no tagged port-channel id number
INTERFACE
VLAN
Remove the port channel with tagging enabled
from the VLAN.
no untagged port-channel id number INTERFACE
VLAN
Remove the port channel without tagging
enabled from the VLAN.
Command Syntax Command Mode Purpose
ip address ip-address mask [secondary] INTERFACE Configure an IP address and mask on the interface.
• ip-address mask: enter an address in
dotted-decimal format (A.B.C.D) and the mask
must be in slash format (/24).
• secondary: the IP address is the interface’s
backup IP address. You can configure up to eight
secondary IP addresses.