Dell Force10 C150 Configuration Guide

880 | Routing Information Protocol
www.dell.com | support.dell.com
When the RIP process has learned the RIP routes, use the show ip rip database command in the EXEC
mode to view those routes (Figure 385).
Figure 42-2. show ip rip database Command Example (Partial)
To disable RIP globally, use the no router rip command in the CONFIGURATION mode.
Configure RIP on interfaces
When you enable RIP globally on the system, interfaces meeting certain conditions start receiving RIP
routes. By default, interfaces that are enabled and configured with an IP address in the same subnet as the
RIP network address receive RIPv1 and RIPv2 routes and send RIPv1 routes.
Assign IP addresses to interfaces that are part of the same subnet as the RIP network identified in the
network command syntax.
FTOS#show ip rip database
Total number of routes in RIP database: 978
160.160.0.0/16
[120/1] via 29.10.10.12, 00:00:26, Fa 0/0
160.160.0.0/16 auto-summary
2.0.0.0/8
[120/1] via 29.10.10.12, 00:01:22, Fa 0/0
2.0.0.0/8 auto-summary
4.0.0.0/8
[120/1] via 29.10.10.12, 00:01:22, Fa 0/0
4.0.0.0/8 auto-summary
8.0.0.0/8
[120/1] via 29.10.10.12, 00:00:26, Fa 0/0
8.0.0.0/8 auto-summary
12.0.0.0/8
[120/1] via 29.10.10.12, 00:00:26, Fa 0/0
12.0.0.0/8 auto-summary
20.0.0.0/8
[120/1] via 29.10.10.12, 00:00:26, Fa 0/0
20.0.0.0/8 auto-summary
29.10.10.0/24 directly connected,Fa 0/0
29.0.0.0/8 auto-summary
31.0.0.0/8
[120/1] via 29.10.10.12, 00:00:26, Fa 0/0
31.0.0.0/8 auto-summary
192.162.2.0/24
[120/1] via 29.10.10.12, 00:01:21, Fa 0/0
192.162.2.0/24 auto-summary
192.161.1.0/24
[120/1] via 29.10.10.12, 00:00:27, Fa 0/0
192.161.1.0/24 auto-summary
192.162.3.0/24
[120/1] via 29.10.10.12, 00:01:22, Fa 0/0
192.162.3.0/24 auto-summary

Dell Force10 C150 Specifications

General

Brand	Dell
Model	Force10 C150
Category	Server
Language	English