Dell Force10 C150 - Log Changes in Peership States; Terminate a Peership

630 | Multicast Source Discovery Protocol
www.dell.com | support.dell.com
Log Changes in Peership States
Terminate a Peership
MSDP uses TCP as its transport protocol. In a peering relationship, the peer with the lower IP address
initiates the TCP session, while the peer with the higher IP address listens on port 639.
Once the relationship is terminated, the peering state of the terminator is SHUTDOWN, while the peering
state of the peer is INACTIVE.
Figure 28-15. Terminating a Peership
Task Command Syntax Command Mode
Log peership state changes.
ip msdp log-adjacency-changes
CONFIGURATION
Task Command Syntax Command Mode
Terminate the TCP connection with a peer.
ip msdp shutdown
CONFIGURATION
[Router 3]
R3_E600(conf)#ip msdp shutdown 192.168.0.1
R3_E600(conf)#do show ip msdp peer
Peer Addr: 192.168.0.1
Local Addr: 0.0.0.0(0) Connect Source: Lo 0
State: Shutdown Up/Down Time: 00:00:18
Timers: KeepAlive 30 sec, Hold time 75 sec
SourceActive packet count (in/out): 0/0
SAs learned from this peer: 0
SA Filtering:
Input (S,G) filter: myremotefilter
Output (S,G) filter: none
[Router 1]
R1_E600(conf)#do show ip msdp peer
Peer Addr: 192.168.0.3
Local Addr: 0.0.0.0(0) Connect Source: Lo 0
State: Inactive Up/Down Time: 00:00:03
Timers: KeepAlive 30 sec, Hold time 75 sec
SourceActive packet count (in/out): 0/0
SAs learned from this peer: 0
SA Filtering: