Dell Force10 C150 - Encrypt FTSA Messages

352 | Force10 Service Agent
www.dell.com | support.dell.com
To add a recipient, you first create a mnemonic label for it. FTOS uses this label to create an FTOS context
in which you can configure the E-mail parameters for the recipient. For example, the default recipient is
Dell Force10 TAC and the label for this recipient is Force10. FTOS creates the context
conf-callhome-Force10 in which you can configure the parameters for E-mails destined for Dell Force10
TAC only, as shown in Figure 16-2.
Figure 16-2. Displaying the Default FTSA E-mail Recipient Configuration
To add a recipient:
Encrypt FTSA Messages
Encrypting FTSA message to a recipient other than the default is supported only on platforms: c e
Step Task Command Command Mode
1 Create a mnemonic label for the recipient.
server label
CONFIGURATION
2 Enter the recipient E-mail address in the form
username@domain-name.com.
recipient email-address
CONFIGURATION
FTOS(conf-callhome)#show config
!
call-home
no enable-all
server Force10
recipient ftsa@force10networks.com
keyadd Force10DefaultPublicKey
encrypt
no enable
FTOS(conf-callhome-Force10)#?
enable Enable call-home service for this server
encrypt Encrypt emails for this server
end Exit from configure mode
exit Exit from call-home server mode
keyadd Add server's public key for encryption
log-messages Add log information
no Reset a command
recipient Enter server email
show Show call-home server configuration
FTOS(conf-callhome-Force10)#show config
server Force10
recipient ftsa@force10networks.com
keyadd Force10DefaultPublicKey
encrypt
no enable