236 | Border Gateway Protocol IPv4 (BGPv4)
www.dell.com | support.dell.com
The BGP fast fall-over feature is configured on a per-neighbor or peer-group basis and is disabled by
default.
To disable Fast Fall-Over, use the
[no] neighbor [neighbor | peer-group] fall-over command in
CONFIGURATION ROUTER BGP mode
Use the
show ip bgp neighbors command as shown in Figure 10-22 to verify that fast fall-over is enabled
on a particular BGP neighbor. Note that since Fast Fall-Over is disabled by default, it will appear only if it
has been enabled
Command Syntax Command Mode Purpose
neighbor {ip-address |
peer-group-name} fall-over
CONFIG-ROUTER-BGP Enable BGP Fast Fall-Over
To Next Page
Loading...
