Dell Force10 C150 - Page 773

PIM Sparse-Mode | 773
Verify PIM-SM Snooping
To display information about PIM-SM snooping operation, enter one of the following show commands:
To clear tree information learned through PIM-SM snooping from the PIM TIB, enter the
clear ip pim
snooping tib
command.
To clear information on the multicast routes learned through PIM-SM snooping from the IPv4 multicast
snooping table, enter the
clear ip mroute snooping command.
The following examples show the PIM-SM snooping output displayed for these
show commands.
Figure 34-10. PIM-SM snooping: show ip pim snooping neighbor
Task Command Command Mode
Display information about PIM neighbors
discovered by PIM-SM snooping.
show ip pim snooping neighbor [vlan
vlan-id]
Figure 34-10
EXEC Privilege
Display information about PIM group members
and states stored in the tree information base
(TIB) that was discovered by PIM-SM snooping.
show ip pim snooping tib [vlan vlan-id]
[group-address [source-address]]
Figure 34-11
EXEC Privilege
Display information about the VLAN interfaces
on which PIM-SM snooping is configured.
show ip pim snooping interface [vlan
vlan-id]
Figure 34-12
EXEC Privilege
Display information about the current operation
of PIM-SM snooping globally on the switch or
on a specified VLAN.
show ip pim summary
Figure 34-13
EXEC Privilege
VLAN INTERFACE
Display information on the multicast routes
discovered on VLANs configured for PIM-SM
snooping.
show ip mroute snooping [vlan vlan-id]
[group-address [source-address]]
Figure 34-14
EXEC Privilege
Display information about the current
configuration of PIM-SM snooping on the
switch.
show running-config pim
Figure 34-15
EXEC Privilege
Display the current configuration of PIM-SM
snooping on a VLAN.
show configuration
Figure 34-16
VLAN INTERFACE
FTOS#show ip pim snooping neighbor
Neighbor Interface Uptime/Expires Ver DR Prio
Address
165.87.32.2 Vl 2 [Gi 4/13 ] 00:04:03/00:01:42 v2 1
165.87.32.10 Vl 2 [Gi 4/11 ] 00:00:46/00:01:29 v2 0
165.87.32.12 Vl 2 [Gi 4/20 ] 00:00:51/00:01:24 v2 0