Dell Force10 C150 - Page 817

Port Monitoring | 817
Figure 38-3. Number of Monitoring Ports on the C-Series and S-Series
In Figure 38-4, 0/25 and 0/26 belong to Port-pipe 1. This port-pipe again has the same restriction of only
four destination ports, new or used.
Figure 38-4. Number of Monitoring Ports on the C-Series and S-Series
A source port may only be monitored by one destination port (Message 6), but a destination port may
monitor more than one source port. Given these parameters, Figure 38-1 illustrates conceptually the
possible port monitoring configurations on the C-Series and S-Series.
Message 5 One Destination Port in a Monitoring Session Error Message on C-Series and S-Series
% Error: Exceeding max MG ports for this MD port pipe.
Message 6 One Destination Port per Source Port Error Message
% Error: MD port is already being monitored.
FTOS(conf)#mon ses 300
FTOS(conf-mon-sess-300)#source gig 0/17 destination gig 0/4 direction tx
% Error: Exceeding max MG ports for this MD port pipe.
FTOS(conf-mon-sess-300)#
FTOS(conf-mon-sess-300)#source gig 0/17 destination gig 0/1 direction tx
FTOS(conf-mon-sess-300)#do show mon session
SessionID Source Destination Direction Mode Type
--------- ------ ----------- --------- ---- ----
0 Gi 0/13 Gi 0/1 rx interface Port-based
10 Gi 0/14 Gi 0/2 rx interface Port-based
20 Gi 0/15 Gi 0/3 rx interface Port-based
30 Gi 0/16 Gi 0/37 rx interface Port-based
300 Gi 0/17 Gi 0/1 tx interface Port-based
FTOS(conf-mon-sess-300)#do show mon session
SessionID Source Destination Direction Mode Type
--------- ------ ----------- --------- ---- ----
0 Gi 0/13 Gi 0/1 rx interface Port-based
10 Gi 0/14 Gi 0/2 rx interface Port-based
20 Gi 0/15 Gi 0/3 rx interface Port-based
30 Gi 0/16 Gi 0/37 rx interface Port-based
100 Gi 0/25 Gi 0/38 tx interface Port-based
110 Gi 0/26 Gi 0/39 tx interface Port-based
300 Gi 0/17 Gi 0/1 tx interface Port-based
FTOS(conf-mon-sess-300)#