Use the command-line interface Establish a remote connection
Digi TransPort WR Routers User Guide 110
Establish a remote connection
Once you have finished configuring the router, there are several ways of establishing a link to a
remote system:
▪ Use the ATD command to make an outgoing V.120 call.
▪ Initiate a DUN session to establish a dial-up PPP connection.
▪ Make an outgoing X.25 call using the ATD command followed by the X.28 CALL command.
▪ Make an outgoing TPAD (Transaction PAD) call using the TPAD a (address) command followed
by the appropriate NUA. This is normally only carried out under software control.
Similarly, incoming calls are handled according to the protocols that have been bound to the ASY
ports, and whether answering is enabled for each protocol.
To Next Page
Loading...
