Configure network interfaces Configure Wi-Fi interfaces
Digi TransPort WR Routers User Guide 176
Wi-Fi Filtering
You can restrict access to the router via Wi-Fi. When the filtering is enabled, only MAC addresses
configured in the table will be allowed to connect to the router.
Enable Wi-Fi filtering
Enable Wi-Fi filtering so that only clients who have their Wi-Fi MAC address configured in the MAC
address table will be allowed to connect.
MAC Address
MAC addresses of Wi-Fi client that you wish to allow access to.
A valid MAC address has the format: 11:22:33:44:55:66. When entering this parameter, omit the
: separators. For example, 112233445566.
Note Carefully review settings before applying changes. Incorrect settings can make the
TransPort device inaccessible from the Wi-Fi network.
Wi-Fi Filtering CLI commands
Entity Instance Parameter Values Equivalent web parameter
wifi 0 macfilter on/off Enable Wi-Fi filtering
wififilt n mac MAC address with no
separators, such as
112233445566
MAC Address
To Next Page
Loading...
