Digi TransPort WR31 - Transport WR11 HSPA+ Model Hardware Features

Hardware TransPort WR11 hardware
Digi TransPort WR Routers User Guide 25
Green: TransPort device is powered
4 Cellular antenna connector: This SMA female connector connects the device’s primary cellular
antenna.
TransPort WR11 HSPA+ model hardware features
1LAN port: Connects the device to a 10/100 base-T Local Area Network (LAN). The port can
perform auto-sensing for speed and wiring, so it can accept straight-through or cross-over cable
connections.
2Power connector: This locking power connector connects the device to a power source. The
connector should be inserted and rotated to lock in place. Center pin is positive.
3 LEDs:
• SERVICE LED: Indicates the presence and level of cellular service running on the device.
Off: No cellular service
1 Blink: GPRS mode
2 Blinks: EDGE mode
3 Blinks: UMTS mode
4 Blinks: HSDPA mode
5 Blinks: HSUPA mode
• SIGNAL LED: Indicates strength of cellular signal.
Off: Poor or No signal. Place the device in a location where it gets a better signal.
Amber: Fair
Green: Good
• POWER LED:
Off: No power
Green: TransPort device is powered
2
1
3
4
5
6