Configure security settings Command filters
Digi TransPort WR Routers User Guide 728
Calling Numbers
The Calling Numbers page has a table that accepts a series of telephone numbers, each of which
has an associated Answer or Reject parameter, and, for numbers from which calls are to be
rejected, a user-defined reason code. For each number set to Reject, the router rejects incoming
calls from that number using the reason code specified. The reason code is a numeric value chosen
to suit the particular application. If any of the entries is set to Answer, the router only answers
incoming calls from that number and rejects calls from other numbers using a standard ISDN reject
code.
Note Only experienced personnel should use this feature for network testing and fault diagnosis.
It is not required for normal use. To use this feature, the ISDN circuit must support the
Calling Line Identification (CLI) facility. If CLI is supported, incoming calls from specified
numbers can be answered normally or rejected with an optional reject code.
Number
The telephone number to either answer or reject.
Mode
The drop-down list in this column selects either Answer to answer calls or Reject to reject calls.
Reject Code
The reason code pertaining to the rejection of the call.
Related CLI commands
Entity Instance Parameter Values Equivalent web parameter
rejlst n num up to 20 digits Number
rejlst n ans off, on Mode Answer,Reject
rejlst n code 0-255 code
To Next Page
Loading...
