Digi TransPort WR31 - AT Commands

Use the command-line interface AT commands
Digi TransPort WR Routers User Guide 111
AT commands
Digi TransPort supports AT commands and Special registers (S registers). Information and
command descriptions in this section includes:
▪ The AT command interface
▪ AT commands are case-insensitive
▪ Entering multiple commands
▪ Escape sequences
▪ AT command result codes
▪ S registers
▪ D command: Dial a call
▪ H command: Hang-up
▪ Z command: Reset
▪ &C command: DCD control
▪ &F command: Load factory settings
▪ &R command: CTS control
▪ &V command: View profiles
▪ &W command: Write SREGS.DAT file
▪ &Y command: Set default profile
▪ &Z command: Store phone number
▪ \AT command: Ignore invalid AT commands
▪ \LS command: Lock speed
▪ \PORT command: Set the active port for text commands
▪ \smib commands
▪ S register definitions