Configure Remote Management SNMP parameters
Digi TransPort WR Routers User Guide 670
SNMP settings
Enable SNMPv1
Enables/disables support for version 1 of the protocol.
Enable SNMPv2c
Enables/disables support for version 2c of the protocol.
Enable SNMPv3
Enables/disables support for version 3 of the protocol.
Use UDP Port n
The UDP port number to use. The default is UDP port 161.
SNMPv3 Engine ID
Required as part of the SNMP v3 protocol. This is a 24-hexadecimal character string; any trailing
zeros in this string making the value up to 24 characters can be omitted. A remote engine ID is
required when a SNMP v3 Inform is configured. The router uses the remote engine ID to compute
the security digest for authenticating and encrypting packets sent to a user on the remote host.
To Next Page
Loading...
