Digi TransPort WR31 - Configure Secure Shell (SSH) Server Parameters

Configure Secure Shell (SSH) server and client Configure Secure Shell (SSH) server parameters
Digi TransPort WR Routers User Guide 478
Configure Secure Shell (SSH) server parameters
Configuring SSH is performed on the Configuration > Network > SSH Servers page. Parameters
are as follows:
Enable SSH Servers
Enables or disables the SSH servers on the router.
SSH Server n parameters
The router supports eight individual SSH servers that are configured independently using the
options described below.
Enable SSH Server
When enabled, enables the SSH server.
Use TCP port p
The TCP port number (default 22) that the SSH server will use to listen for incoming connections.
(Port 22 is the standard SSH port).
Allow up to n connections
The number of sockets listening for new SSH connections (default 1).