Configure security settings User security settings
Digi TransPort WR Routers User Guide 682
Related CLI commands
Change the default username and password for a user
By default, the username for each supported user is username and the password is password. To
increase security, change the username and password for device users from these defaults.
Note Record the new password. If the changed password is lost, the router must be reset to the
default firmware settings.
In the web interface:
1 From the main menu, navigate to Configuration > Security> Users> User n.
2 In the Username field, enter the new user name. Up to 14 characters are allowed in a username.
For additional details on the username, see User system security setting.
3 In the Password / Confirm Password field, enter the new password. For additional details on the
password, see User system security setting.
4 Select the access level for the user: Super, High, Medium, Low, Read Only, or None.
Descriptions of these access levels is in User system security setting.
Click Apply. From the command line:
Issue the user command, specifying the name, password, and access parameters.
Entity Instance Parameter Values Equivalent web parameter
user 0 name String
(up to 40 chars)
Username
user 0 password String
(up to 40 chars)
Password
user 0 access 0=Super
1=High
2=Medium
3=Low
4=None
8=Read Only
Access Level
To Next Page
Loading...
