Configure IP routing and forwarding Static routes
Digi TransPort WR Routers User Guide 372
Related CLI commands
Entity Instance Parameter Values Equivalent web parameter
route n metric 0-2147483647 Use metric n when the interface is not active
route n srcip Valid IP address
a.b.c.d
IP Address a.b.c.d
route n srcmask Valid netmask
a.b.c.d
Mask a.b.c.d
route n inrip on,off Include this route in RIP advertisements
route n doinact2 on,off Make PPP n interface use the alternative idle
timeout when this route becomes available
route n inact2add 0-2147483647 Make PPP n interface use the alternative idle
timeout when this route becomes available
route n pwr_dly 0-255 Wait for s seconds after power up before
allowing this route to activate the interface
route n actooslim 0-2147483647 Mark this route as Out Of Service if the
interface fails to connect after n consecutive
attempts
route n chkoos_int 0-2147483647 If the interface fails to connect, try again in s
seconds
route n chkoos_deact 0-255 Deactivate the interface after it successfully
connects
route n dial_int 0-255
Default 10
Do not allow this interface to be activated by
this route for s seconds after the last activation
attempt
route n q1 on,off Only queue one packet whilst waiting for the
interface to connect
route n deact_ent Blank,PPP When this route becomes available,
deactivate the following interfaces x,y
route n deact_add 0-2147483647 When this route becomes available,
deactivate the following interfaces x,y
route n deact_ent2 Blank,PPP When this route becomes available,
deactivate the following interfaces x,y
route n deact_add2 0-2147483647 When this route becomes available,
deactivate the following interfaces x,y
route n unoos_secs 0-2147483647 Keep this route in service for s seconds after
OOS state is cleared
route n rgroup 0-255 Assign this route to recovery group n
To Next Page
Loading...
